01845nab a2200217 4500 20260520004413.0 260224s2012 xxu ing Inglés Heavy-Oil Recovery by In-Situ Emulsion Formation jun. 2012 12/12/2012 ; 12/12/2012 8 p. ; 326-334 Transcripción del resumen del autor The aim of this work is to evaluate alkaline/surfactant (AS) methods to improve recovery from heavy-oil reservoirs. Alkali/surfactant/oil phase-behavior experiments were conducted to determine conditions under which oil-in-water (O/W) emulsions form. The viscosity (and its shear dependence) was measured for some of these emulsions. Reservoir sand was assembled in sandpacks. Waterflood and AS floods were conducted at several salinities. Several relatively hydrophilic surfactants were identified, which formed O/W emulsions with the reservoir oil at a low concentration in the presence of sodium carbonate. O/W emulsions were favored at low salinity and high water/oil ratio (WOR). Viscosity of these emulsions was low compared with the oil viscosity. Waterflood recovery was on the order of 25 to 40% of the original oil in place (OOIP) in corefloods, and it decreased as the injection rate increased. Following the waterflood, the AS flood gave an incremental oil recovery of 10 to 35% of OOIP. The incremental post-breakthrough oil recovery during the waterflood is likely because of the imbibition of the water from viscous fingers into the unswept oil-saturated zone; this recovery is directly proportional to the square root of time. 2 SPE Journal 17 ARTICULO Kumar, R. 52862 Dao, E. 52863 Mohanty, K.K. 6563 187494 187494 0 0 0 0 255313 BAAB BAAB 2026-03-06 200059613 0 200059613 2026-03-06 00:17:23 2026-03-06 ARTICULO