01880nab a2200205 4500 20260520001830.0 260224s2010 xxu On the end-effect correction for Couette type oil-field direct-indicating viscometers for Newtonian and non-Newtonian fluids mar. 2010 12/07/2010 ; 12/07/2010 10 p. ; 37-46 Transcripción del resumen del autor. Analysis and experimental results are presented which quantify the magnitude of end-effects for direct- indicating, narrow gap, rotating cylinder viscometers used extensively in oil- eld, for Newtonian and non- Newtonian uids. Such viscometers have already embedded at manufacturing stage an end-effect correction and give directly the shear stress which does not allow end-effect quanti cation in a straight forward manner. The presented analysis resolves this problem by estimating the embedded correction, which has been determined as 6.69% of the torque developed along the cylindrical part of the stationary bob of this viscometer. Experimental results with Newtonian and non-Newtonian uids show that there is no additional end-effect from the bottom of the stationary bob. However, there is additional end-effect contribution from the top section of the bob, which has not been taken into account in the design and manufacturing of the instrument. Its magnitude ranges from 5 to 6% for the Newtonian uid and the high shear rate range for the non- Newtonian uid, to 12% for the low shear rate range for the non-Newtonian uid tested, while the impact on drilling situations is also discussed. 1-2 Journal of Petroleum Science & Engineering 71 ARTICULO Kelessidis, V.C. 38573 Maglione, R. 45600 Bandelis, G. 45601 174936 174936 0 0 0 0 242755 BAAB BAAB 2026-03-05 200046814 0 200046814 2026-03-05 18:52:27 2026-03-05 ARTICULO